Instead, use a clean dry cloth or paper towel. Make sure you don’t use water to clean uncured paste. Now that your project or repair is complete, it’s time to clean up. Before your next use, remember to remove any dry Flex Paste that may have dried, or skinned inside of the container. It’s all up to you!ĭon’t wipe any excess Flex Paste on the inside of your container, because that could lead to drying. Just smooth it to your desired finish, or add your own artistic texture. Spackle and joint compound require sanding, with Flex Paste light sanding is possible, but not recommended. Remember, it is very important to replace the protective foil as much as possible while you are working to keep your unused Flex Paste from drying out. Flex Paste FULLY cures within 24-48 hours. Once Flex Paste is exposed to air or moisture or humidity it begins to cure, forming a skin within 15 to 30 minutes. How long does it take for Flex Paste to dry? Also, you may need to apply a little extra Flex Paste when working underwater. For best results, you may want to do some etching in order to increase adhesion. Yes, Flex Paste will work underwater and on wet surfaces. Remember to replace the protective foil as much as you can while working to prevent drying during application.Ĭan I apply Flex Paste on wet surfaces or underwater? It’s important to always allow each coat to dry before applying additional coats. Don’t scoop too deep! Scooping too deep can cause air pockets that dry out the Flex Paste.Īpply a generous amount of paste to the surface using smooth even motions. With Flex Paste, there is no need to shake or stir, it’s already ready to go! Grab a putty knife, trowel or similar tool, and remove an even layer of material from the top of the tub. You’re going to need both your foil and silica pack later. Then carefully remove the protective foil. You see that moisture-absorbing silica pack? Remove it, put it aside and save it! Using a flat head screwdriver, remove the lid. You can use painter’s tape and a drop cloth or plastic to protect other surfaces. Protect areas that you don’t want Flex Paste to ensure clean lines. It needs to be free of grease, oil and dirt. It’s a good idea to wear protective gloves, clothing, and eye wear. Then follow along with the blog for a comprehensive step by step guide. To get the most out of your Flex Paste, make sure you READ THE DIRECTIONS CAREFULLY.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |